The Wirelink (CWL) and Wirevise (CWV) can fasten H-T wires without a tool. Merely insert the wires into the holes.The wires are gripped by spring-loaded clamps which tighten more securely as the wires are pulled harder, holding the wires at over 80% of the breaking strength of the wire itself.
To use the Wirevise , drill a 3/8 inch hole through the end post and pull the wire through the hole. Then put the Wirevise on the wire and tap it lightly into the hole. If final tensioning is to be done with the Wirevise, it is recommended to pull the wire to the end post with a chain grab, then push the slack through the hole and Wirevise. A special tightening tool (TVT) is also available for use with the Wirevise. It grabs the wire which has been threaded into the Wirevise and a simple prying action pulls the wire through the Wirevise to the desired tension.
A TWR wire release tool can be used to remove most 12.5 gauge Wirelinks from the fence wire. |
china.qy6
Home >> Product >> Electronics & Electrical >> Others >> Wirevise
Return Electronics & Electrical Market
Top of Page
Contact